Farmall & IHC Tractors Discussion Board |
Looking for painting advice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom Windsor on May 05, 2007 at 18:37:12 from (75.117.83.71):
With the projects that I have done in the past couple of years, I just clean up the sheet metal and the frame, prime and paint it. I have given no detail to the sheet metal preparation other than clean, prime and paint. So, I get out in the real world and start seeing things that people do and I find some "great" sheet metal paint jobs. The one I have going now, I want it to also be "great." So here is where I need advice and schooling. All of you have seen the rust pits in the sheet metal. I need to know how to cover them up. I looked for some 1/2 inch paint and did not find it :-) I want to get a good coat of epoxy or etching primer on the bare metal...then, I want to fill the pits before the final paint. There is where I am lost--somewhere between the good primer and the final paint. I need to know exactly how to cover and fill in the rust pit holes in the sheet metal! TW
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|