|
Farmall & IHC Tractors Discussion Board |
Re: Super A rear control arm
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by SuperA-Tx on May 03, 2007 at 09:33:32 from (4.227.105.29):
In Reply to: Super A rear control arm posted by scotty on May 03, 2007 at 08:18:19:
If you have the original arm on there and not one from another tractor then I might be able to help some. The spring is about 2 3/4 inches long and has a gap of about 1 1/4. I looked and looked for one and ended up getting a compression spring from Fastenal. The gauge and length were right but the opening was a little to small. I heated it up and bent it open some then stuck it on a 1" water pipe and just beat it til it was back straight and loked right. The part number was 110166728. There are two in the bag so if you mess up one theres always a spare. Cost $5.85. #54 compression spring. 
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
