Farmall & IHC Tractors Discussion Board |
Hole in a super C...kind of long
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by matt(PA) on May 02, 2007 at 05:07:04 from (12.172.247.101):
Morning. This is probably going to be confusing (no pictures), but I am stumped, so here goes. A little bit aft of where the torque tube joins the rear, underneath the tractor, there is an approximately 3/4" hole in the casting. It looks to have been cast there (not broken out), as it is perfectly centered on the flat area, at the front point. Any idea what this hole might have been for? Maybe a bolt is missing that is supposed to be in there? My problem is that rear end fluid seems to be leaking out of it (very slowly, just damp), and I would like to put a stop to it. Hopefully this description is somewhat clear! Ha! I do own an operators and a parts manual, but I couldn't find a picture of the area in question in either of them.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|