Farmall & IHC Tractors Discussion Board |
Cub charging update
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by DAN WV on May 01, 2007 at 10:01:37 from (207.255.218.215):
Well I rewired the entire tractor with all new wire and all connections soldered together. and guess what? Still no charging. another new regulator and still nothing. I cleaned all the spaces between the gen and VR brackets and still nothing. I took a wire directly to the positive (ground) side of the Battery back to the VR base and it started charging. About 8 amps. Now the question I have is the purpose of the 3 position light switch. When I turn it to "D" the ammeter goes almost all the way to full discharge, When I turn it to "B" the ammeter reads just barely discharging. all this about 3/4 throttle. Is this the correct function of the switch? I was under the impression that the system would not charge much until the light switch was turned to"D". Then it would have the system start charging. Thanks again.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|