Farmall & IHC Tractors Discussion Board |
Re: IH 574 Brakes
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike Van on April 25, 2007 at 15:00:03 from (24.151.104.209):
In Reply to: IH 574 Brakes posted by jim-in-NY on April 25, 2007 at 12:10:23:
Jim, this info is from the 574 service manual, you should get one - It says there are screens, one on top of the master cyl. on the "keep fill" line, and another under the hood above the battery on the brake orifice assembly. These may be plugged? There"s 15 pages on the brakes in there, and I type poorly. Real quick on bleeding - 1. run the tractor for a minute to insure brake lines are full. 2. clamp the brake reservoir inlet hose to prevent fluid from returning to the resevoir. 3. attach 1/4" hoses to the 2 bleeder fittings & route them to the oil fill plug. 4. Loosen the bleed screws until fluid is running free of air out the two tubes. 5. Latch the brake pedals and depress & raise slowly until fluid is free of air. Tighten one bleed screw & repeat until fluid is free of air. Allow pedals to return to raised position & tighten second bleed screw. Hope that helps.
Replies:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|