Farmall & IHC Tractors Discussion Board |
Re: Question on governor spring.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by ChadS on April 20, 2007 at 14:33:37 from (65.151.85.25):
In Reply to: Question on governor spring. posted by unioncreek on April 20, 2007 at 06:54:10:
New idle adjustment screw? If not, some get a ridge built up from wear, and leak and you cant set the idle well. Try blowing the carbs passages out again with high pressure air, check the tiny idle stem, might be plugging up, or its the wrong one,, seen many rebuild kits that give the wrong one. check the mechanical advance in the distributor,, they are usually broke or stuck, if the rotor does not have a good spring snap to it, or feels like it moves but no spring action, the advance is moving the timing back and forth erraticly,, which can also cause a surge in the governor/carb. Replace the springs with new ones, or get some from a Chevy HEI distributor recurve kit, (sold at bout any auto parts store) Check the distributor first, before you tear into the carb,,, might be whats up? Chad
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|