Farmall & IHC Tractors Discussion Board |
Farmall 350 hydraulic pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Agpilot on April 19, 2007 at 18:21:32 from (206.146.78.170):
Hello all. It"s been a couple years since I"ve been on YTmag. I searched back to last Dec for any hint on replacing the Hyd pump on a 350 rowcrop. I saw a pump for $523 under Farmall parts but I was wondering if there are any other possible ways to get the pressure back up. Have any of you access to rebuilt pumps? Yes, I know there is always buying used ones which may or may not work. Buyer beware etc... The 3 valve assembly is rather loose too. Been used too much over the last 50 years. I can always buy a new pump but I thought this would be a good chance to get back on YTmag and ask for other suggestions.. Thanks all. Agpilot
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|