IH RED: If you can remove the piece from spreader you may be able to straighten it with hammer...might have to "soften" it up some with heat. I would be hesitant to try to do that on the spreader for fear of knocking/pulling something else outta line...and you will find it easier to work on the concrete floor than in the air. Might need something to lay in/under channel to "block" it in place to keep from getting it too badly mishapened as you are getting it back closer to the desired form. Might also consider cutting it carefully somewhere towards the middle... and after straightening you can weld it back. The near side bend may be a bit of a challenge, but with time and patience you can work that out also. Do as much as you can with as little heat as you can avoid. An extra set of hands may come in handy especially if you try to do it one piece.
Straightening metal can be a challenge, but takes time and patience. Have fun and good luck!!
Would like to hear how you come out with problem...possibly with an "after" photo.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
