Farmall & IHC Tractors Discussion Board |
Help! 240 Power Steering Not Working
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mark Peters on April 18, 2007 at 13:09:26 from (69.129.255.9):
I just got done installing a factory PS setup that I got from a salvage yard into my 240. I cleaned everything up and went thru the regulator,safety/flow control valve block. The pistons were stuck and found a broken spring in the auxiliary safety valve located in the flow control valve. I reassembled the valve according to the I/T manual. I thought all looked good, but when I started the tractor,NO power steering! I fiddled around,tried more RPM`s,nothing I did made the PS work. The fast hitch worked great, no laboring or anything. I then pulled on one of the hydraulic remote levers and guess what ,the PS works when one of the hydraulic levers are pulled and held. As soon as you let go of the lever and let the hydraulics go to neutral, the PS stops working. I`m stuck and don`t know what to do. Is it possible the flow control valve is plain worn out? The flow control valve didn`t look like a bad fit to me, but I`m no hydraulics expert. Or possibly a weak flow control valve spring?? I`m open to any and all ideas! Thanks,Mark
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|