Farmall & IHC Tractors Discussion Board |
Re: Width of a F-20
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by J.J, from Afton on March 31, 2007 at 15:20:54 from (66.41.83.1):
In Reply to: Width of a F-20 posted by SDE on March 31, 2007 at 14:01:32:
Nope it wont work that way. The F-12s and F-14s have wheels that can be adjusted on the axle so the total width of those two is at the end of the axles, unless of course the wheels are placed to extend beyond the axle. The F-20 however does not have wheels that can be adjusted by sliding them on the axle. The wheels bolt to the hubs which are in a fixed position, so the only way to adjust the width is to swap the back wheels around. If i remember correctly the standard tread F-20 is around 84 inches wide, possibly a couple more inches. However there was also the narrow tread F-20 which had shorter axles before the dropped housings but i cannot recall how wide that one measures.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|