Farmall & IHC Tractors Discussion Board |
Re: C135 piston sleeve question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Roger Mills on March 22, 2007 at 12:22:43 from (71.37.118.105):
In Reply to: Re: C135 piston sleeve question posted by georgeky on March 22, 2007 at 06:41:54:
Call the company that made the kit, they should know (maybe). If all is normal with this engine then there will be a groove at the bottom of the bore. Use a wire brush on a dremmel or similar and clean the inside of the bore and the groove. Make sure there are no burrs etc. Use a liquid soap on outside of sleeve and inside of bore. When you slide the sleeve in look from below to make sure the o-ring stays in groove when sleeve goes past it. Most, but not all, sleeves have a bevel or taper at bottom outside to help this. Others may have more help on the best way, I just know this method works for me.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|