|
Farmall & IHC Tractors Discussion Board |
Re: Roosa-master Injection Pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Owen Aaland on March 21, 2007 at 14:51:44 from (65.165.246.14):
In Reply to: Re: Roosa-master Injection Pump posted by georgeky on March 21, 2007 at 06:27:55:
As long as you are going into the pump you may want to consider replacing all the o-rings and seals. The flexible washer like piece that holds the weight retainer to the drive plate is especially prone to failure. Hopefully you cleaned the outside of the pump well before removing from the tractor. There are a number of special tools listed but you should be able to get by without them. I use a hog pan with a couple of inches of stoddard solvent in it and put all the pieces in there as I remove them. Clean diesel will also work, just smells a bit more and is a little oilier. The only adjustment you will need to upset is the rod the the governor spring rides on. Crack the lock nut loose and the count the number of turns it takes to remove the rod. Write this down so you have it when you are reassembling the pump. All the other adjustments you should be able to leave alone. Take your time and take note of anything you are not completely sure of as you take it apart. Keep everything clean and follow the manual and you should have no problem.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
