Farmall & IHC Tractors Discussion Board |
cannot get m to run right
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scott in Illinois on March 19, 2007 at 19:05:18 from (71.171.185.161):
I have a 51 M i just bought and I cannot seem to get to run right. It pops and sounds like it is missing at idle and half throttle but will smooth out pretty good under load. Carb has been went thru and I cannot find any air leaks,I even tried the propane torch trick I have heard about. I adjusted the valves also. I replaced plugs and have checked all plug wires as well. I did not replace points but they looked fine and point gap was fine. I am running out of ideas and am almost at my wits end. Hopefully some of you who have a lot more experience can help with ideas. Any would be appreciated. Thanks in advance... Scott
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|