Farmall & IHC Tractors Discussion Board |
well,kb826
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by russ hamm on February 21, 2007 at 17:50:47 from (63.245.179.200):
In Reply to: Re: wierd science/ 10-20 pistons and sleeves posted by K.B.-826 on February 21, 2007 at 17:07:25:
they are wet sleeves. and actually you are on point. we could put them in upside down half way and shine a light below. looking from the top the sleeves are either egg shaped or the pistons are. BUT the kicker is that we only pulled one sleeve and the next one went in fine. and the pistons came out better than some iv'e done. my guess is someone had this apart, pressed the pins in and egged the pistons, then it siezed and bent a rod, then when we took it apart we thought the other three were rust stuck but they might have been actually that tight to begin with.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|