Excellent point. Somebody in a post down below mentioned pictures which can be helpful, too.
Something I always do is bag up and LABEL!! small parts. I use brown paper candy and lunch bags, but Zip-Locs work good, too. Then I can wind up with all my head nuts in one bag, the nuts and washers for the manifold in another with the bolts and/or nuts to mount the carb to the manifold in another. In the same line as your suggestion on keeping the rods and caps straight, I apply that to main caps, lockplates and nuts, as well, each set getting their own candy bag, LABELED!! for their position, and the lot of them going into a larger lunch bag to keep them together. For things that look alike but come out in order, like push rods, I label them individually for where they were before they go in the bag.
It may be overkill and a little obsessive (potty filter wouldn't let me use the ana- word!), but there's an AWFUL lot of 3/8" and 5/16" bolts on one of them things and it sure helps when putting things back together to have the right bolts of the right length and any nuts to go with them when you go bolting things like oil pumps, distributors, governor, . . . back onto a motor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
