The reason IH came out with a low ash for gasoline is that they were trying to get a long life oil to use in all their engines. They found that they needed two different types of oil to make things work. When they added more ash content the spark ignition engines developed many more valve problems. Failures in 300 to 700 hours on test engines.
Sulfur in the diesel fuel when mixed with water becomes sulfuric acid. The ash in the oil neutralizes that acid. To get to a hundred hour oil change interval they increased the ash content. This is why you should not use a low ash oil in your diesels, though with the low sulfur fuels the need for the higher ash content is greatly lessened.
The increased ash content caused problems with the newer gasoline engines by leaving carbon deposits on the exhaust valve stems. This doesn't cause much of a problem for an engine that is run under a uniform load. The problem comes when an engine is run with a partial load and then fully loaded or overloaded. The increased load raises the temperature of the valves and the increases temperature causes the valve stems to expand. The valve stems with the carbon deposits on them no longer have enough clearance and they will hang open instead of fully closing. The hot combustion gases passing by the partially open valve will burn it out just like using a cutting torch on it. When it happens it is very rapid, only a few revolutions of the engine. It was very common to see this type of failure in the spring and fall as these tractors went from light duty to heavy tillage. Using low ash oils will greatly reduce this type of failure on these engines.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
