Farmall & IHC Tractors Discussion Board |
Rebuilt M Engine Won't Start
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on January 23, 2002 at 17:08:22 from (165.121.51.205):
I have rebuilt a M engine that was apart when I purchased the tractor. I used new sleeves, rings, rod bearings, and piston pin bushings. The pistons were reused and are flat top 4" pistons from a Farmall 400. The head was reworked. Carb was built. New coil. The crank was not removed, and the distributor and governor remained on the tractor and have not been moved. I am getting 90 psi of compression at cranking speed-I think this is correct for a overbore with flat top pistons. When I try to start the engine, it will hit while cranking, but never take off. The engine acts like it is not getting gas, but I see no reason why it should not. Could I have a problem with the governor where it connects to the carb. I have rechecked to see that the linkage tab is in the correct slot on the carb. How can I check the linkage? The plug wires are as follows: #1 at 2:00, #3 at 10:00, #4 at 8:00, and #2 at 4:00. Is this the correct wiring order? All I am doing is running batteries down. Thanks in advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|