Farmall & IHC Tractors Discussion Board |
Re: Super M disc brakes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Old-Dutch on January 16, 2002 at 10:37:35 from (216.165.148.209):
In Reply to: Super M disc brakes posted by scott on January 16, 2002 at 10:19:34:
Scott-do not machine anything off of those actuators, by doing that you will throw off the distance that they apply at and can run into a locking situation that i'm sure that if it ever happens you are sure not to forget believe me. Clean them good and at this point I would replace the springs, by cleaning I mean, take some coarse sandpaper or emery cloth and scour them good, also do that part that it sits on in the cover their should be three on outer rim. When you replace the disks put the sharp edge of the inner bore-the splined edge of disk away from actuator. When you put your pull rod on and adjust it, make sure to clean that pocket where the ball from the pull rod sits in and clean that ball thoroughly, put on some anti-seize to remove any friction there. That should about do it, and good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|