Farmall & IHC Tractors Discussion Board |
Re: Re: 560 3pt. hitch?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Keith B on January 08, 2002 at 07:46:42 from (216.151.70.121):
In Reply to: Re: 560 3pt. hitch? posted by Don H on January 07, 2002 at 18:03:37:
I have a 560 and love the fast hitch. I have purchased the 3 pt adapters and they are not as slick as one might think. First, there are two styles of these adapters. One set comes straight out and the other set angle up. The set I purchased come straight out and end up mounting the implements too low. On some of my implements I was able to lower the mounting pins to accommodate but not all. Second, since the width of your arms are fixed, you have to be careful when buying older 3pt implements. Some are too wide or too narrow to work. This also can make hooking up implements tricky, but not impossible. Third, the top link on these adapters is somewhat suspect. Never seems to work quite right with a back blade and most of the times requires a really short top link. Well, that's been my experiences, thus, I try to only use fast hitch implements! Keith
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|