Farmall & IHC Tractors Discussion Board |
Re: SC ring gear
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on January 06, 2002 at 19:11:26 from (128.59.6.179):
In Reply to: SC ring gear posted by J3nut on January 06, 2002 at 15:59:48:
There is a difference in the two sides. The side the bendix would catch has a slight bevel to it. Hard to believe looking at it that it could make a lot of difference, but it does. If your existing gear is otherwise in good shape and you have the tools, you might try putting a bevel edge on the flat side. As for getting it off and back on, a little heat and some tapping around it with a brass rod or an oak dowel should get it off. To put it back on, I'd use a torch or an oven (if the bride is out of the house) to get the ring up to about 500 degrees, especially if the old side is chewed up. That should expand it enough to keep any burrs and whatnot from making problems putting it back in place. Good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|