Farmall & IHC Tractors Discussion Board |
Re: Re: Re: IH 230 rebuild
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on January 05, 2002 at 05:18:04 from (207.172.109.31):
In Reply to: Re: Re: IH 230 rebuild posted by TerryC(MO) on January 04, 2002 at 17:22:53:
Yes, an intake not opening all the way restricts the air mixture that is about to be compressed, and either valve not closing all the way allows compression to leak off or not build at all. While the valve cover is off, you can check torque on most of the cylinder head nuts. If you pick up the rocker arm assy you could check the torque on all of them. I'm not saying this is your silver bullet, but it would be my first step. Other advice you've received is good. I typically go .020 cold on intake and exhaust. Thanks for the compliment Ralph. But try not to be so loose with the term expert! ;) ;) (at least in relation to myself) Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|