Farmall & IHC Tractors Discussion Board |
Re: 400 stuck in two gears
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MN Charlie on December 31, 2001 at 18:42:11 from (216.188.194.81):
In Reply to: 400 stuck in two gears posted by Doug Stevenson on December 31, 2001 at 15:43:06:
When you have all the shifter rails lined up and letting the clutch out kills the engine your problem is in the transmission not in the bull gear area of the tractor. Yesterday I removed the transmission cover from an "H" that I'm helping my brother-in-law restore. This tractor is in South Central MN setting out in a COLD pole shed. The oil was drained earlier this fall and yesterday we removed the cover to check out all of the gears and bearings. We were surprized to see a large chuck of ICE in the transmission preventing the bottom shaft from turning. With a steel bar we were able to breakup the ice and get things turning for inspection. When my broth-in-law drained the transmission last fall he only drained the large plug at the rear, I guess I forgot to tell him about the drain plug at the front of the transmission. There was still enought water left in the trans. to prevent the shaft from turning. Yesterday was Dec 27 and it was cold. Build a big fire, or wait untill spring to change oil and water and refill with Hy-Tran. Good Luck
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|