Farmall & IHC Tractors Discussion Board |
Splitting the Mule, the final chapter
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on December 19, 2001 at 06:01:15 from (129.37.117.101):
A while back, I put on a post about splitting my Hebard Shop Mule to fix the clutch. Things would not stop turning forever when the clutch was disengaged. I found that someone had put in a non IH bronze pilot bushing that was not tight in the end of the crank shaft. There was also some residual of the rats nest in there that I had not been able to get out through the hand hole in the bottom. Anyway, had the clutch refaced, new throw out bearing and new IH pilot bushing. (even though the clutch facing and pilot bearing looked good) It already had been converted to the ball bearing throwout bearing. Everything works much better, but it still requires a few seconds of waiting for the transmission to quit turning if the tractor has been running with the transmission in neutral. But, at least if will stop now if you wait that few seconds. Just wanted to give a report on the outcome.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|