Re: electrall on 400 IHC

Posted by DAN on December 18, 2001 at 16:19:49 from (216.106.38.75):

In Reply to: electrall on 400 IHC posted by Richie on December 30, 1999 at 19:33:18:

THERE IS A PICTURE OF AN ELECTRALL LISTED IN THE DICUSSION BOARD, I DON'T RECALL THE LOCATION BUT IT IS SET UP AS A STAND BY POWER PLANT. I BOUGHT ONE OF THESE UNITS SEVERAL YEARS AGO FOR $50.00 AND AFTER CLEANING UP THE SLIP RINGS IT WENT TO WORKING JUST FINE. THE GUY I BOUGHT IT FROM TOLD ME THAT I.H.C. EXPERIMENTED WITH THESE UNITS AND THAT THE ONE I HAVE WAS USED TO RUN A PULL TYPE COMBINE,ELECTRIC MOTORS BEING USED IN PLACE OF BELTS AND CHAINS FOR ALL THE VARIOUS FUNCTIONS. ( I DO NOT KNOW IF THIS IS TRUE OR NOT BUT THE MAN WAS SINCERE SO I HAVE NO REASON TO DOUBT HIM.) THE UNIT I HAVE HAS 115/VOLT AND 230/VOLT SINGLE PHASE, AND ALSO A 208/VOLT THREE PHASE OUTLET. THREE PHASE BEING BETTER TO RUN MOTORS WITH BECAUSE THEY HAVE MORE POWER FOR THEIR SIZE AND DON'T OVER HEAT AS OUICK. I HAVE USED THIS ONE TO RUN A LINCOLN WELDER WITH AND IT SEEMED TO HANDLED IT NO PROBLEM. SINCE ALL I GOT WAS THE ALTERNATOR I DON'T KNOW IF IT HAD SOME SEPERATE CONTROLS FOR FINE TUNING VOLTAGE AND THE CYCLES OR NOT. IT IS RUN BY V-PULLEY AN HAS WHAT I SUPPOSE IS A EXCITER GENERATOR (DELCO) TO CHARGE THE COILS OR AS A FIELD FLASH. THIS SMALL GEN. IS RAN OFF THE MAIN SHAFT VIA NARROW GAUGE V-BELT ALSO. HOPE TO RUN ACROSS A MANUAL SOME DAY.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: electrall on 400 IHC Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]