Farmall & IHC Tractors Discussion Board |
Re: Farmall M/H and JD 45 loader MOUNTING brackets
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jerry S on December 18, 2001 at 14:13:49 from (63.71.59.98):
In Reply to: Farmall M/H and JD 45 loader MOUNTING brackets posted by Kenny Christopherson on December 18, 2001 at 13:49:08:
Kenny, My first time in this board but wanted to share with you what I was told. I bought a 45 loader and the brackets on it were not the right width for my JD A so I had them modified to fit. After that, I was told that it likely was made to fit an IH. What they are in difference to the ones made for a JD is that the bolt on bracket is a flat piece of steel rather than the curved deal the JD's used. If you took the vertical piece of a JD bracket and had it cut off the bolt on piece, you can then take a good piece of flat steel and align it up for your tractor's axle and weld it on the upright piece. It would be easier to buy the bracket upright part rather than build it I would think. The rest is a fairly easy modification. I adjusted the brackets based on driving the tractor into the loader and marking it. I just left room to get a wrench on the bolts and 10 minutes later it was welded and ready to go. Because of the clutch pully on my A it had to go further right than an IH would have to. Hope this helps you.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|