Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Re: Magneto problem


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by walt f on December 16, 2001 at 20:26:42 from (24.159.78.155):

In Reply to: Re: Magneto problem posted by walt f on December 16, 2001 at 15:25:53:

you haven't changed anything since the tractor last ran? if not then verify that you've got spark by putting a piece of copper wire in one of the plug holes and turning it toward the engine block, but away from it about 1/8 in. i use a piece of wire like you would find in a piece of romax or house wire like in the walls, 12 guage wire skinned back a half in. on one end, then turned back and pressed in the plug tower, the other end turned toward the block for the spark to jump across the 1/8 in gap. i use the stiff wire so i don't have to hold it when it aparks. when i crank the engine over i look for the spark to occur every fourth snap of the impulse in the magneto. no spark? then i try to get the tip of the stiff wire as close as possible and try again. still no spark, then i open up the magneto to inspect the points to see if they are opening. (here you should go over to the allis chalmers board to ask for help because the allis tractors almost exclusively use the fairbanks morse magnetos). if you've got spark, and it's good fat white at 1/4 in. then check for fuel, take out one of the spark plugs to see if its wet, no then see if you can see the obvious. open the drain plug on the carb and drain it into a small clean coffee can and notice if it flows non stop for a min. look down in the can to see if there is water in the gas. if it's been in there long then the water will be rust colored, this is bad because the carb. is cast iron and the rust will clog the jets. turn the gas drain plug off after a min. if it's clean then pour it back in the tank. if you have fuel and spark then you will get fire, mabey back fire, in which case you will need to check the firing order. hope i've helped.


Follow Ups:




Post A Followup

:
:

: Re: Re: Re: Magneto problem

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy