Farmall & IHC Tractors Discussion Board |
Re: Hydraulic Ports On C??
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on December 11, 2001 at 19:00:05 from (129.37.117.100):
In Reply to: Hydraulic Ports On C?? posted by 1PWRFULH on December 11, 2001 at 16:39:13:
A while back someone posted pictures of the set up they got from Saginaw County Tractor with their 3 point hitch for the C. I suppose you could buy just the hydraulic parts from Saginaw. I believe the post said the cost was $100 plus shipping. The setup included a machined block that mounts between the hydraulic manifold (the pipes from the touch control to the pump)and the touch control. They also include a spool valve. You have to supply the hoses and fittings and couplers. Once the block is in place, you take the rear plug(has a 1/4 inch socket head plug in it) out of the manifold. That is the supply to the spool valve. The return from the spool valve goes to the new block. I've thought about investigating and getting one of these. I did take out the plug out of the manifold and stuck a gage in there to see how much pressure. My C makes max of 1500 psi, which I think is about the specification.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|