Farmall & IHC Tractors Discussion Board |
Re: Steering nut and carb woes
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on December 07, 2001 at 13:41:08 from (129.37.117.66):
In Reply to: Steering nut and carb woes posted by Dave Z on December 07, 2001 at 11:24:24:
The big plug with the hex on it is the retainer for the bearing outer race. The plug should clamp against the outer race of the ball bearing on the steering shaft and hold it tightly in the steering gear housing. If it does not, you will have to find some shim rings to put in there to make it clamp up. The nut on the end of the steering shaft holds the inner race of the bearing. If should clamp the inner race tightly against the shoulder on the shaft. The nut is a 3/4 inch fine thread castle nut. there is a hole in the shaft for a cotter pin to keep the nut from coming loose. I had to put a washer behind my castle nut to get things to work right, but the washer must not bind against the bearing balls or the outer race.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|