Farmall & IHC Tractors Discussion Board |
Re: International 350 Utility Clutch Problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rodney on December 05, 2001 at 16:04:16 from (12.81.203.162):
In Reply to: International 350 Utility Clutch Problems posted by Daron on December 05, 2001 at 09:11:13:
How much sludge came out? Both an engine rear seal or transmission leak can give you some sludge as the oil mixes with spent clutch facing. A small amount (a cup or less) shouldn't cause too much trouble. Moisture in the clutch compartment is usually the culprit that causes the discs to stick. Oil in the clutch compartment would help this, a little. Having no pedal resistance would make me check my linkage to be sure everything is pushing and turning like it should. Take off the inspection plate, drain out the sludge, and you should be able to look inside the clutch compartment while a helper runs the pedal. Be sure the "fingers" of the clutch are moving, and that you have some free play.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|