Farmall & IHC Tractors Discussion Board |
Re: 3pt Hitch Prototype
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by grimreaper on November 17, 2001 at 05:48:57 from (207.150.152.156):
In Reply to: 3pt Hitch Prototype posted by Alabama on November 15, 2001 at 14:56:44:
You suffer from the same disease I do, to wit: an urge to reinvent the wheel. Just bought a SC (my first full size tractor)and my first activity was to lay out the geometry for arms attached to the rocker shaft to drive a 3 point hitch. If you figure your time the cost of doing it yourself is far, far higher than buying something already "debugged". Of course if you are doing it for the satisfaction that's another matter. Good luck with your project. John (PS please don't take above as criticism-I suffer from the same impulse-built a sailboat many years ago, could have bought 3 if I included the value of the time, etc.)
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|