Farmall & IHC Tractors Discussion Board |
Re: 3pt Hitch Prototype
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zonie on November 15, 2001 at 20:57:48 from (64.12.104.33):
In Reply to: 3pt Hitch Prototype posted by Alabama on November 15, 2001 at 14:56:44:
I built a 3 point for my H, used 3"X3"X3/8" Angle iron, attached it to the existing draw bar and draw bar mounts, set it up to use 1 4" X 8" cylinder. I bought the ball and socket ends for the lift arms and added the 3/4" X 2 1/2" barstock to make my own lift arms. I bought the lift arm pins, ball and sockets, and other misc. hardware at my local John deere dealer (I know beat me with a stick), they were cheaper than any I could find any where else, and I didn't have to pay shipping or have to wait for them to arrive by mail. I have not taken any pictures yet, nor have I had a chance to test the operation, that will have to wait till I get the engine back together. Email me if you need any more specifics
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|