Farmall & IHC Tractors Discussion Board |
Re: H/M drawbar exchange
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Dukester on November 11, 2001 at 18:42:55 from (216.93.118.232):
In Reply to: H/M drawbar exchange posted by JimBub on November 11, 2001 at 15:59:50:
IH used to make a drawbar plate to use with heavy tongue loads because the swinging hitch would bend under heavy loads. The plate was triangular in shape and patterened to bolt to any of the outer holes in the several grouped three hole layouts in the "U" shaped stationary drawbar(000 000 000)etc. ^ ^ ^ ^ ^ ^ The plates came in two different sizes, one with the single pull hole about 6 inches from the attatching two holes and one with the pull hole about 10 inches or a foot back, but you could make one any way you want with 3/4 inch plate and a cutting torch. The plates would fit the two drilled and tapped holes in the front wheel post so it could make a nice front drawbar to push wagons or whatever around with too. (0 0) ^ ^
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|