Farmall & IHC Tractors Discussion Board |
Clutch replacement - 560 Farmall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Matt Clark on November 11, 2001 at 05:21:06 from (199.120.77.252):
All right, need some help. Didn't think I'd need the manual to do this, so we don't have one. Turns out, the clutch was OK, but the throwout bearing went bad and ruined the bearing carrier, and the bushing that it rides in. 1. Any ideas where I can get these items used? IH is pretty proud of them, and trying to show the wife I'm "saving" money 2. Can anybody fax (563/288-1526) the page from the manual that shows how these 2 items are installed (it's all ground to pieces and I really can't tell by looking how they go), or a scan would be great, too. 3. How thick are the brake disks supposed to be? Tore into them as well as they are pretty grabby, but clean and dry but glazed. Any help would be greatly appreciated. So far, it's been a lot of fun, but just trying to safe a few bucks. Thanks in advance - I sure hope someone can help a newbie. Matt Clark
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|