Farmall & IHC Tractors Discussion Board |
Re: Points and Condensor
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Ed on November 09, 2001 at 17:46:16 from (209.240.222.132):
In Reply to: Points and Condensor posted by Cary on November 09, 2001 at 10:59:50:
If your tractor still has a magneto this may get you close.I allways start by putting the #1 cyl at TDC compression stroke just in case I lose the timing.The Electrode on the rotor should be pointing to the #1 position on the distributer cap.Then remove the rotor and there should be three screws holding a plate remove these be careful not to get the little gear out of position that runs the rotor.The points are under this plate.You should be able to tell how they mount at this point.I belive th gap is .013 on the high lobe. Take the cap off the mag and you will see how the condenser mounts.This is the best I can remember,my book is 10 miles out in the country.Put it all back like it was and hope you dont have to retime.ED
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|