Farmall & IHC Tractors Discussion Board |
Re: Temp sending unit on M
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmer Bob on November 08, 2001 at 18:20:24 from (66.152.73.231):
In Reply to: Temp sending unit on M posted by Pigster on November 08, 2001 at 08:57:17:
Pigster, If you go the new OEM IH Gauge route check the thread pitch on the bushing that holds the probe into the other bushing that threads into the head. The outside threads on the base head bushing is std. 1/2"I.P thread. It's the inside threads on that one that have to match the threads on the bushing that holds the probe in the head. I did the same as you and even when I bought the new IH Gauge, I had to change the bushing in the head to accept the other bushing.//FB
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|