Farmall & IHC Tractors Discussion Board |
F-20 Cam Followers
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mr. J on November 07, 2001 at 14:31:27 from (204.184.253.248):
My F-20's cam followers, or lifters I guess, are stuck. Does anyone have any ideas on how to unstick the cam followers or how hard would it be to replace them? I have tried only diesel fuel and oil at this time to loosen them. I am going to try a good soak with WD-40 and see what happens. At this point I have the block off of the tractor. The crank, cam, and flywheel are still on the tractor. There is one guide that is broken and cracked as well. I guess you are supposed to drive the cam follower/push rod guides through the top side of the block. Also, is the lifter and the push rod guide one piece or can it be seperated? Thanks in advance. Mr. J
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|