Farmall & IHC Tractors Discussion Board |
Re: Re: 460 farmall belt alignment problem
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Charlie Warren on November 07, 2001 at 10:10:07 from (64.216.135.50):
In Reply to: Re: 460 farmall belt alignment problem posted by kev@ia on November 05, 2001 at 15:56:03:
Thanks for the help, I looked at mine again last night, don't see a bolt and just a single groove pulley. Everything is tight, after looking closer the generator & crank pulley seem to be in line, the pulley on the water pump is too far out, about a belt width. Pump is ok, looks like maybe the wrong one has been installed at some time. I'd like to know more about this tractor, but doesn't seem to be a lot out there on it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|