Farmall & IHC Tractors Discussion Board |
Re: Sale prices and a question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by The Dukester on November 04, 2001 at 11:13:04 from (216.93.118.32):
In Reply to: Sale prices and a question posted by Phlogiston on November 03, 2001 at 15:18:35:
Yeah, that long wrench with the big socket on one end and the "crank" sort of handle was the cultivator/drawbar wrench. When you mounted the cultivators on H's, M's and later "Supers" and some of the early number models you had to remove the drawbar because it interfered with the cultivator brackets and rear gangs. First thing to do was to remove the drawbar by dropping out the swinging hitch part pin under the transmission housing and then loosening the nuts(4) on the drawbar mounts to the rear axle housings, swing the eyebolts up and down and remove the drawbar assembly. That's where the wrench was used and was very handy. You also used it to attatch the cultivator rear gangs to similar mounts on the axle housings and on a similar "swinging eyebolt" mount. I learned how to mount a HM438 cultivator on my Super M pretty fast, it took a little muscle like most of the equipment did in those days,but you could do it and was happy with it.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|