Farmall & IHC Tractors Discussion Board |
Re: 460 with plow
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J. D. Humm on November 04, 2001 at 07:39:48 from (12.65.216.213):
In Reply to: 460 with plow posted by Mn Charlie on November 04, 2001 at 07:14:17:
I have a 311 plow- fast hitch also. Have you tried adjusting the angle of the hitch prongs? Mine has three different holes the prongs can bolt up to to change their angle. Also the plow should not set level (parallel) with tractor axle. The rh side of the plow should be higher than the left, when the plow is in the ground and the RH tractor wheel is in the furrow the plow should be laterally level (parallel) with the ground. The nose of the plow should be slightly lower than the tail when it just starts into the ground. Good plow shares will also help. I spent many hours with one of those plows behind a 656 after school working evenings when I was a kid. That was the good old days.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|