Farmall & IHC Tractors Discussion Board |
Re: Re: Re: New Rod Bearings didn't work!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on October 26, 2001 at 05:00:41 from (207.172.109.68):
In Reply to: Re: Re: New Rod Bearings didn't work! posted by Dick Davis on October 26, 2001 at 04:18:32:
Dick, What did the old inserts look like when removed? any copper showing? Are all the rod caps with the correct rods? If you didn't notice the rods being loose when reinstalled, you might want to keep looking until you isolate it. It's usually harder to find a low oil pressure problem when nothing is knocking yet. If it's loud enough to knock, you should be able to find what's loose. Maybe use a dowl like a stethescope(sp?) and locate the source as high/low front/back in the motor. Other possibilities could be the small end of the rods (when you drop the rod cap, is the piston loose on the rod?); valve train/rocker troubles (usually a slower knock, 1/2 of engine rpm); timing gears can come loose on the crank or cam ... And then there's your real problem, which is always the last thing I come up with ;-) Good Luck, Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|