Farmall & IHC Tractors Discussion Board |
Re: New Rod Bearings didn't work!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ralph on October 25, 2001 at 16:34:41 from (65.45.140.49):
In Reply to: New Rod Bearings didn't work! posted by Dick Davis on October 25, 2001 at 11:43:23:
Dick: I seem to remember your earlier post but not the details. Low oil pressure?? That can be from several areas. Rod bearings have less surface than all the mains so there can be a big loss from the mains. A weak oil pump? An oil pressure guage that is no longer reading correctly.(I had that happen just a couple months ago) You can do a lot of checking on the crank BEFOR taking it out. Have someone "mike" the rod journals. Try using plasticgauge on the mains in 3 or 4 places per bearing to check for "out-of-round" mains. Does the bearing surface look chewed up? Or is there wear only part way around indicating out of round problem? I don't mean to prevent you from a complete job but rather just a few ways to check BEFOR all the work and expense. Skip these suggestions if your mind is set for taking it apart. Either way, good luck. ralph
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|