Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Re: Re: Re: Trailer Safety


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Andy Martin on October 25, 2001 at 15:51:51 from (63.27.17.29):

In Reply to: Re: Re: Re: Trailer Safety posted by scotty on October 25, 2001 at 06:15:34:

One of the main things in my mind when loading or unloading a tractor is confidence. After you get a trailer which will haul the tractor, and suitable ramps, you don't get scared and try to stop half way up or down. Get on and go. A rear wheel falling off a ramp is not as hazardous as trying to stop in mid-operation. Loading old crawlers with bad brakes is how I learned-don't stop, just have a little confidence and keep on trucking. A crawler climbing the back of a bob-tail truck is an open-air thrill cause you can't see anything until it rocks over center and you discover whether you are still on the truck.

I used to move tricycle M's on a high trailer with only two ramps. Had to stop and reposition one ramp after the rear wheel cleared. If the rig was on less than level ground, and the rear of the trailer was a little high the rear wheels would not clear before the fron twheels started off. So I've bounced the front off with no ramp. I've also cramped the front of the tractor to one side and backed off in a circle to put one rear wheel and the front wheels down the same ramp without repositioning but there's a tire hanging partly off a ramp all the time. It is easy to load that way: drive up from one side instead of behind the trailer, put the front wheels up the far ramp while the rear wheel climbs the side of the near ramp, with your foot on the near brake spin the front wheel up the ramp and get the other rear wheel in position to go on up. But don't try the clutch, you'll slide sideways and get hung up.

Getting 10% of the tractor weight on the truck is much more important than which direction you load it. I like going forward on an unfamiliar trailer to see what is happening. It will always come off.

By the way, when tying down, remember the most important thing is trying to keep the tractor out of the truck during a panic stop so do the best tie job to the back of the trailer. You can't accelerate fast enough to put much of a load toward the rear so the tie to the front is not nearly so important.


Follow Ups:




Post A Followup

:
:

: Re: Re: Re: Re: Re: Trailer Safety

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy