Farmall & IHC Tractors Discussion Board |
Re: Re: International 2444 PTO
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by NEAL S. on October 24, 2001 at 12:14:45 from (216.165.157.66):
In Reply to: Re: International 2444 PTO posted by BILL SMITH on October 21, 2001 at 19:46:09:
Andy you are correct in assuming it is english design, and a two stage clutch. Usually what happens is the shaft that goes into the clutch housing that you clutch pedal is attatched to slips. so before going to far take the cover off below the clutch housing with a flashlight look intowards the fingers on the pressure plate and while some one presses the pedal down see if everything is moving or the pivot pins are rusted. If rusted shoot some wd-40 at the pins avoiding getting it to wet. when it is working a little freer you should feel a step where the second stage releases. although at this point as I said, you are going to readjust your clutch, with a wrench on the flat of the release shaft coming from the housing hold it just so you have clearance at the fingers at clutch. Then re tighten the two clamp bolts on pedal. you should have an adjustment stop bolt on the pedal or tang on tractor to give you clearance also. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|