Farmall & IHC Tractors Discussion Board |
Re: Re: hydraulics on 400 farmall
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brad Evjen on October 19, 2001 at 17:13:26 from (12.158.184.34):
In Reply to: Re: hydraulics on 400 farmall posted by jmyt_47 on October 19, 2001 at 07:45:38:
thanks for the reply jmty 47. Ihave a belhen unit on the tractor. I didnt do a good job of explaning my problem though.The power steering works good its the rest of the hydraulics that is weak. I think the problem is in the flow control and regulator block.there is a saftey valve for the power steering that is supposed to maintain pressure in the system but i cant figure out how to access it. the way iunderstand it if this valve is bad the system wont build enough pressure.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|