Farmall & IHC Tractors Discussion Board |
Re: eating plugs
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F14 on October 11, 2001 at 16:31:01 from (216.252.28.95):
In Reply to: eating plugs posted by datche on October 11, 2001 at 15:38:28:
You say "new carb", but was it set up properly? I don't think it's safe to assume you can take a new or rebuilt carb out of the box, bolt it on and expect it to be right on. Check the float level, fuel inlet needle and seat, and mixture screws. Did you put new plug wires on? Are they compatible with a magneto, or are they generic wires designed for a distributor or electronic ignition? Have you tried going one range hotter on the plugs? Was the mag checked out when the engine was rebuilt?
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|