Farmall & IHC Tractors Discussion Board |
Re: Farmall 450 noises
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny Frisk on October 11, 2001 at 10:30:51 from (12.4.181.2):
In Reply to: Farmall 450 noises posted by BEL on October 11, 2001 at 04:33:37:
Dad's 450 did that too when He had it back in the late '60's. First check to make sure the wheel clamp bolts are tight, the 4 that clamp the cast wheel to the axle. While Your doing that check to make sure the rim clamp bolts are tight. If they all check out O-K, Your problem is probably the same as Dad's was. The bull pinion shaft bearings are getting bad and the pinion shaft is walking back & forth against the bull gear. Pull the brake housing off and try wiggling the shaft real hard. Get a manual before You try to remove the bearing housing. There's also a slim chance it may be the rear axle carrier bearings but a real slim chance.
Follow Ups:
Home
| Forums
Today's Featured Article -
New Life for an Old Allis - by Tyler Woods. My friend Jon, has an old '39 Allis Chalmers B. He thought it a marginal tractor that had long since served its time. She smoked terribly and never had much power but he couldn't afford another so he was limping along with what he had. Jon's Allis has a small front loader and though it doesn't carry much, it serves his needs. It was the hard starting and low power that made him think it was time to replace the old girl. Jon called me to help him discover why his tractor wouldn't start
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|