|
Farmall & IHC Tractors Discussion Board |
Re: Build or buy a front blade for Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scotty on October 04, 2001 at 05:32:39 from (199.231.49.128):
In Reply to: Build or buy a front blade for Super A posted by marvin on October 03, 2001 at 08:01:50:
Marvin,
I have a 1942 A that im just finishing building a snow blade for.It started life as a
cub blade which I widened to just under 6 ft and
made it about 15 in high.I made a bracket that
goes between rear housing of tractor so Ill be
pushing from the rear.Then I built a frame 60 in
long that goes under tractor from rear to just under 1 1/2 square hole on steering box.Built
another frame that goes from steering box sq hole
down to plow level.That is were the pivot takes
place on a 1 in pin.So the 60 in frame is welded
to the front frame which is bolted to a piece of
1 1/2 in stock that goes through hole on steering
box.I am using strong arm lift with a pulley setup
for lifting.Hope this helped.Ileft my E-Mail adr
for questions.
scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
