Farmall & IHC Tractors Discussion Board |
Re: Build or buy a front blade for Super A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by gene b on October 04, 2001 at 03:55:32 from (65.229.174.166):
In Reply to: Build or buy a front blade for Super A posted by marvin on October 03, 2001 at 08:01:50:
i would build one out of some 11ga not too expensive 80bucks for a 4x8 sheet plenty of material for a blade and brackets to mount with made mine 18 high and 5 wide had it broke two places and then had a piece broke u-shaped like a channel welded on the back for strength used 1/2x2 for a edge works fine use the exhaust lift for raising up next progect is a snow blower
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|