Farmall & IHC Tractors Discussion Board |
Re: 300 Utility/Log splitter Question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on October 01, 2001 at 11:02:35 from (165.170.128.65):
In Reply to: 300 Utility/Log splitter Question posted by VAJOE on October 01, 2001 at 10:23:01:
Closed center means when the valve is in the center or neutral position, it blocks the flow from the pump. A pressure-compensated hydraulic pump (essentially a variable volume, constant pressure) is required when using closed center valves. On the other hand an open center valve bypasses full pump flow back, at 0 pressure to the reservoir when in the valve's in the center position. An open center valve is required on non-pressure compensated (constant volume, variable pressure) pump systems. Most simple (hence most early) tractor hydraulic systems are open center. Your 300U is open center. A "detent" valve is one which has a detent to hold it in one (or both) non-neutral positions. When a set pressure is reached in the system, the detent releases the valve back into the center position. On a log splitter typically the valve detent is only for the "return" position. It permits the operator to let go of the valve handle while the ram retracts - when the ram reaches the end of it's stroke it automatically releases the valve back to center.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|