Farmall & IHC Tractors Discussion Board |
Re: putting new wiring in my C light bar
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on September 28, 2001 at 16:43:03 from (129.37.117.165):
In Reply to: putting new wiring in my C light bar posted by Dennis on September 28, 2001 at 14:47:29:
Well, it was a lot of "fun", but I got new wire in on my 1950 C. The old wire was so rotten, it could not be used to pull in new wire. First, as the others said, get everything all cleaned out. Mine was full of dirt, too. Then take out the battery and box if you have one (likely you've already done that). Then push the wire up through from the panel. By shining a light through the bar, you can see when it gets to the bar. Then use a rod, or another wire with a loop in the end to snag the wire and either push it out or pull it on out of the light bar. It's not easy to get the wire around that right angle turn, but it can be done.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|